safetyPLC

safetyPLC

  less than a minute  

The Safety PLC provides information about the state of the Safety PLC and which safety project is applied.

  • The Run Lamp is green if the Safety PLC receives a run command, else LED is switched off.
  • The Acknowledge button is linked to the iErrorAcknowledge. Pressing the Acknowledge button resets the INTERLOCK FUNCTIONS. So that the warnings and error are reset.
  • The Project CRC is a hex number representation of the safety project applied to the safety PLC.
  • The Serial Number is the Safety PLC serial number.
  • The Logic State defines the state of the Safety PLC. The states are: OFFLINE, RUN, SAFE, START, PREPARE, RESTORE or PROJECT-CRC-OK.
  • The Safety PLC SDOs can be read out after pressing the Read SDOs button. This wil request the core temperature and voltage.

The FSoE Communication provides information about the connected slaves.

  • Cmd to/from slave states are: FailSafeData, Reset, ProcessData, Connection or Parameter.
  • The connection ID provides information about the slave ID.